Powermate P-FTT-160MD Engine Preparation Continued, Temp, SAE 10W-30, 100 F, 30 40 C

Models: P-FTT-160MD P-FTT-160MD-[E]

1 48
Download 48 pages 45.97 Kb
Page 11
Image 11
Engine Preparation (Continued)

Engine Preparation (Continued)

• Save all instructions

A Engine Oil

SAE

SAE 10W-30

 

 

 

 

 

 

 

 

 

 

 

SAE 30

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TEMP -20

0

20

40

60

80

 

100° F

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

-30

 

-20

-10

0

10

20

30 40° C

 

 

 

 

Ambient Service Temperature

 

 

 

 

A Engine Oil CAUTION

Engine shipped without oil. Failure to add oil will result in serious engine damage.

A bottle of SAE 30 engine oil is included with your tiller. Refer to the chart on the right for alternative oil types to use at different temperatures. Always use a high quality detergent oil classified “For Service, SG, SH, SJ” or higher. Do not use special additives.

SAE 10W-30 CAUTION

TEMP -20 CAUTION

Frequently check oil level while filling. DO NOT OVERFILL. DO NOT UNDERFILL. Running engine at improper oil level will seriously damage engine.

6.Replace and tighten dipstick.

7.Clean up any spilled oil.

NOTE: THE TRANSMISSION CASE COMES FROM THE FACTORY WITH THE PROPER AMOUNT AND TYPE OF GEAR OIL.

Fuel Tank Cap

Oil Fill Cap/Dipstick

Depth Regulator Lever

Figure 6

Always use recommended oil type. Using dirty oil or incorrect oil type such as 2-stroke engine oil will damage the engine.

NOTE: Engine Oil Capacity is 600 ml. For first time fill, simply add the entire contents of the provided oil bottle to the crankcase.

HOW TO CHECK OIL LEVEL AND FILL TO PROPER LEVEL

100° F WARNING

Before checking oil, make sure engine is off, and spark plug wire has been disconnected from spark plug.

1. Place the tiller on a level surface and make sure the depth regulator lever is set so the main frame of the tiller is level. (See Figure 6)

2.Remove the oil fill cap/dipstick and wipe clean with cloth.

(See Figure 6)

3.Insert dipstick into fill spout but do NOT screw in. Remove dipstick and check oil level.

4.When oil level is full, the oil will be at upper limit on dip stick. If oil level is near or below the lower limit, oil must be added. (See Figure 7)

5.Add oil slowly until the oil level reaches the upper limit of the dipstick. Use a funnel or nozzle to reduce spillage.

Upper Limit

Lower Limit

Oil Fill Cap/

Dipstick

Figure 7

Questions? Call Toll Free at 1-800-737-2112

10

Copyright © 2009 MAT Engine Technologies, LLC

Page 11
Image 11
Powermate P-FTT-160MD Engine Preparation Continued, Temp, SAE 10W-30, 100 F, 30 40 C, Save all instructions, A Engine Oil