Operation (Continued)
• Save all instructions
I Adjustments (Cont.)
BELT TENSION ADJUSTMENT (See Figure 14)
Proper belt tension is critical to good performance. After 1/2 hour of operation, all cables may have to be adjusted due to initial stretch. Thereafter, check tension after every 2 hours of operation.
To increase belt tension
1.Loosen upper jam nut. Turn nut up cable in 1/8” increments.
2. | Tighten lower jam nut. | Forward Cable |
| |
3. | Check adjustment. | Upper Jam Nut | ||
| ||||
|
|
| ||
TO DECREASE BELT TENSION |
| Lower Jam Nut | ||
1. | Loosen lower jam nut. Turn nut down cable in 1/8” |
| Figure 14 | |
| increments. |
| ||
2.Tighten upper jam nut.
3.Check adjustment.
This procedure can be repeated until conduit adjustment bolts are fully adjusted. If no more adjustment can be made, belt may have to be replaced.
J Tilling Tips
The key to successful tilling is to begin with a shallow cut on the first pass, and then work an inch or two deeper on each successive pass.
•Tilling depth will vary with ground conditions.
•When beginning to till in unbroken ground or in extremely hard soil, set the detent pin in the highest hole of the depth regulator lever (follow instructions under Tilling section). This will allow for shallow tilling. With the drag stake in this position, make several light passes over the area to be tilled. Reset for deeper depths with successive passes.
•If tiller jumps or skids uncontrollably, lower the drag stake by placing the detent pin in a higher hole. This will allow for shallower tilling. Hold firmly to the handlebars to control sudden lurches.
•If weeds, tall grasses, vines, or other materials clog or jam the tines, reverse the tiller to unwind vegetation.
WARNING
Immediately release the drive control levers if the tines jam or you strike a foreign object. With drive control levers in neutral position, stop the engine. Disengage the spark plug wire. When tines have stopped, remove foreign objects and check for damage.
K | Cultivating Tips |
If you plan to use your tiller for cultivating:
•Plant rows on 20" - 22" centers for ease of turning.
•Set the depth regulator lever with the detent pin in one of the higher holes. This will allow for shallow cultivation necessary to turn over weeds, and break up and aerate the soil.
WARNING
Extreme caution must be taken in selecting tilling depth. If you attempt to till too deeply for soil con- ditions, that is, with the depth regulator lever in too high a position, loss of control could result.
If removing material from the tines by hand, stop engine and remove spark plug wire first.
Questions? Call Toll Free at | 14 | Copyright © 2009 MAT Engine Technologies, LLC |
