Powermate P-FTT-160MD-[E] DEPTH REGULATOR LEVER See Figure, H Clutch Lever, I Adjustments

Operation (Continued)

• Save all instructions

H Clutch Lever	I Adjustments
CAUTION	WARNING

This information is provided here only to intro- duce the controls. Do not start the engine at this time. Starting and operating instructions are given on page 11. Please read this section and all operat- ing and safety instructions before starting your tiller.

Engine should be off before adjusting any controls.

WARNING

DO NOT FIX THE CLUTCH LEVER IN DRIVE POSITION BY ANY OTHER MEANS THAN MANUALLY USING YOUR RIGHT HAND. DO NOT TIE OR OTHERWISE SECURE THE LEVERS IN DRIVE POSITION.

•To stop the tines at any time release the CLUTCH levers.

CLUTCH LEVER (See Figure 13)

Engages tines into forward. Pushing down the clutch lever toward the handlebar engages the tines. Releasing the lever stops the tines and brings the tiller to a complete stop.

DEPTH REGULATOR LEVER (See Figure 2)

Tilling depth is controlled by the height of the depth regulator lever. To adjust tilling depth:

1.Remove pin and cotter key.

2.Raise the depth regulator lever to position tines at chosen tilling depth.

3.Align hole in depth regulator lever with hole in depth regulator bracket and replace pin and cotter key.

Depth Regulator Lever Down = Shallower tilling.

Place the pin in the top hole of the depth regulator lever for shallowest tilling.

Depth Regulator Lever Up = Deeper tilling.

Place the pin in the bottom hole of the depth regulator lever for deepest tilling.

Forward Lever Engaged

WARNING

Do not adjust tilling depth unless Clutch lever is released and engine is turned off.

Figure 13

Questions? Call Toll Free at 1-800-737-2112 13 Copyright © 2009 MAT Engine Technologies, LLC