Powermate PM0105000 manual Portability KIT Installation, Wheel Installation

PORTABILITY KIT INSTALLATION

TOOLS REQUIRED: 10mm, 13mm, and 16mm sockets and ratchets, block(s) of wood (minimum of 6” tall).

Refer to the parts list on page 37.

WHEEL INSTALLATION

1.Block up the engine end of generator to install wheel kit.

2.Insert wheel spacer (item 109) into the center of the wheel (item 108).

3.Slide M10 x 95 bolt (item 107) through the wheel (item 108), then through the wheel bracket on the carrier, with the offset side of the wheel hub against the wheel bracket.

4.Thread M10 nut (item 110) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.

5.Repeat above instructions for the remaining wheel.

FOOT INSTALLATION

1.Assemble the rubber foot (item 113) to the foot bracket (item 114) using a M8 x 30 screw (item 112). Thread a M8 nut (item 111) to the screw to secure the assembly. Caution: Do not over tighten so that the foot material collapses.

2.Blocking up the alternator side of the generator, place the foot bracket under the carrier channel. Thread a M8 x 15 screw (item 115) through the mounting holes and thread a M8 nut (item 111) to the bolt to secure the foot bracket to the carrier.

3.Repeat above instructions for the remaining foot.

HANDLE INSTALLATION

1.Place handle (item 119) on carrier on same end as feet, as shown in the diagram.

2.Slide M6 x 28 screw (item 121) through handle and handle bracket as shown in diagram and secure with M6 nut (item 120). Tighten until handle is securely clamped to the carrier.

3.Apply aerosol hairspray or similar adhesive to the handle (item 119), and then slide the handle grip (item 117) onto the handle. The aerosol hairspray will allow for easier assembly and will adhere the grip to the handle.

LOCKING HANDLE
1. Attach the lanyard (item 118) to the release	1			2
pin (item 122) and carrier as shown in the
illustration.
2. To lock the handle (item 119) in the extended
position, align the holes in the handle bracket
with the holes in the carrier bracket and insert		118	122
the release pin (item 122).

English 8 Customer Hotline 1-800-445-1805