Installing Belt Guard and Door
Refer to Figure 9.
Mount the belt guard over the shaft as shown, and install the knob to secure it in place.
Set the lip of the door over the bottom edge of the stand opening. Rotate the door knob to hold the door to the stand.
NOTE: When the jointer is being operated, the two M6 pan head screws (KK) and M6 flat washers (LL) should be installed to fully secure the door. At this moment, however, leave these screws off until the switch has been installed.
Installing Switch Arm
Refer to Figure 10.
1.Align the holes of the switch arm with the holes on the jointer stand, while slipping the electrical cord down through the larger hole in the stand.
2.Secure the switch arm with four
3.Open the stand door, and join the connectors of the switch cord and motor cord, as shown in the detail in Figure 10.
Installing Dust Chute
Refer to Figure 11.
It is strongly recommended that a dust collection system (not provided) be connected to the jointer. It will help keep your shop clean, and reduce the risk of health problems due to wood dust. The dust collector should have sufficient capacity for this size jointer. Visit our website at www.powermatic.com to see a range of available dust collection units.
Place the dust chute over the opening in the jointer stand, and secure with four
Connect a suitable dust collection hose to the dust chute on the jointer and secure it with a hose clamp. NOTE: Dryer vent hose is not acceptable for this purpose.
Figure 9
Figure 10
Figure 11
(hose and clamp not provided)
11
