Installing Fence Handwheel
Refer to Figure 12.
Install the handwheel (H) onto the shaft, and tighten the set screw with a 3mm hex wrench.
Knife Gauge Assembly (model 60C only)
Refer to Figure 13.
The knife gauge assembly consists of a bar, two end pieces and two
Storing the Push Blocks
The two provided push blocks have a magnetic base – you can attach them to the jointer stand or any metallic surface, to keep them within easy reach.
Electrical Connections
Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be properly grounded to help prevent electrical shock and possible fatal injury.
The Jointer is equipped with either a single phase, 230 volt motor; or a three phase, 230/460 volt motor.
The single phase unit is factory wired for 230 volts. The jointer has a ground plug that looks like the plug illustrated in Figure 14. Or, you may
The three phase motor is
It is recommended that the three phase jointer, when operated at 230 volts, be connected to a dedicated, minimum 20 amp circuit with a 20 amp circuit breaker or time delay fuse. When operated at 460 volts, connect the jointer to a dedicated, minimum 15 amp circuit with 15 amp circuit breaker or time delay fuse. Local codes take precedence over recommendations.
Figure 12
Figure 13
(model 60C only)
Figure 14
12