Preventive Maintenance
Checklist for Model PJ1696 Jointer
Monthly:
[ | ] | Inspect entire machine for loose bolts, nuts, screws. Tighten and replace as necessary. |
[ | ] | Clean table and cutterhead area, removing sawdust and chips with a soft bristle brush. |
|
| Remove gum and pitch with oven cleaner. |
[ | ] | Lubricate adjusting screws beneath infeed and outfeed tables with a good grade non- |
|
| hardening grease. |
[ | ] | Clean table surface. If rusted, use paste mixture of household ammonia, a good |
|
| commercial detergent and 000 steel wool. Wash table down with hot, soapy water, rinse |
|
| and dry thoroughly. Apply a light coat of paste wax, or another commercially available |
|
| protectant to the table surface. |
[ | ] | Check belt condition. Replace as needed. Dress with paraffin. Check belt tension. |
[ | ] | Check motor for loose wiring and sawdust congestion, pulleys tight and in line. |
[ | ] | Check bearings. Replace any bad or suspect bearings immediately. |
[ | ] | Check fence accuracy. |
[ | ] | Check and |
[ | ] | Check electrical controls function. Clean dust from internal parts of magnetic control |
|
| boxes. |
34