Powermatic PM2800B 11.2 Lamp replacement

7. Shut off drill press and disconnect from

power.

8. Remove lower belt in same manner as upper

belt.

9. Use reverse procedure to install new belts.

11.2 Lamp replacement

Referring to Figure 28:

1. To replace a lamp, use a thumbnail or flat

blade screwdriver to gently pry down the lamp

assembly (A) unt il it re lea ses from the seat, as

shown.

2. Unscrew f ront p late (B) f rom head, pull o ut t he

plate, and disconnect the lamp wires from the

electrical board. Remove old lamp assembly.

3. Install new lamp assembly and push it firmly

into the seat. Connect the wires and reinstall

front plate.

Figure 28

Contents

Main Operating Instructions and Parts Manual 18-inch Variable Speed Drill Press This .pdf document is bookmarked Model PM2800B 1.0 Warranty and Service 2.0 Table of contents 3.0 Safety warnings 4.0 About this manual 5.0 Specif ications 5.1 Base Hole Centers for PM2800B 6.0 Setup and assembly 6.1 Shipping contents 6.2 Tools required for setup: 6.3 Unpacking and cleanup 6.4 Assembly Page 6.5 Table insert leveling 7.0 Electrical connections 7.1 Grounding instructions 7.2 Voltage conversion 7.3 Extension cords 8.0 Adjustments 8.1 Table movement 8.1.1 Raise and lower 8.1.2 Swing table away 8.1.3 Tilt table 8.2 Chuck and arbor removal 8.3 Changing spindle speeds 8.4 Depth stop 8.5 Work sto p 8.6 Re turn spri ng 8.7 Laser adjustment 9.0 Operating controls 10.0 Operation 10.1 Installing bits 10.2 Positioning work piece 10.3 General Inspection 11.0 Maintenance 11.1 Belt replacement 11.2 Lamp replacement 12.0 Troubleshooting the PM2800B Drill Press 13.0 Replacem ent Parts Page 13.1.2 Part List for PM2800B