Unpacking

Open shipping container and any smaller boxes and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the planer is installed and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

NOTE: To remove the box from atop the planer table, loosen the table lock handle, push in the elevating handwheel (see Figure 3) and rotate the handwheel to lower the table.

Contents of the Shipping Container

1 Planer

1 Dust Hood – (A)

1RA-30E 460V Overload Relay – (B)

1Handle with Knob – (C)

3Open End Wrenches, 17-19, 22-24, and 12- 14 mm – (D)

4Foot Pads – (E)

4Hex Wrenches, 3, 4, 5, and 8mm – (F)

1Reversible Screwdriver – (G)

2Star Point Screwdrivers – (H)

10Replacement Knife Inserts – (J)

8Lock Washers, M6 – (K)

8Flat Washers, M6 – (L)

8Button Head Socket Screws, M6x12 – (M)

10Knife Insert Screws, #10-32 x 1/2” (N)

1Operating Instructions and Parts Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

8

Page 8
Image 8
Powermatic WP2510 operating instructions Unpacking, Contents of the Shipping Container