Specifications
Model Number | WP2510 |
Stock Number | 1791303 |
Main Drive Motor | TEFC induction, 15HP, 3PH, 230/460V |
Full Load Amperage | 37/18.5A |
Idle Running Amperage (230V) | 10A |
Table Hoist Motor | TEFC induction, 1/2HP, 3PH, 60Hz |
Maximum Cutting Width | 25 in. (635mm) |
Maximum Cutting Thickness | 9 in. (230mm) |
Full Width Cutting Depth | 1/8 in. (3mm) |
Maximum Cutting Depth | 1/4 in. (6mm) |
Minimum Planing Length | 10 in. (250mm) |
Board Thickness Capacity: |
|
Using controller software | minimum 0.16 in. (7mm) / maximum 9 in. (230mm) |
Manually using handwheel | minimum 0.157 in. (4mm) / maximum 10 in. (240mm) |
Number of Knives, Helical Head | 174 |
Segmented Infeed Roll Diameter | 3 in. (76mm) |
Steel Outfeed Roll Diameter | |
Cutterhead Speed | 5,000 RPM |
Cutterhead Diameter | |
Feed Rate | |
Table Size (L x W) | |
Dust Port Diameter | 5 in. (127mm) |
Capacity, Main Gearbox | 3.042 L (0.8 gal) |
Capacity, Table Hoist Motor Gearbox | 1.524 L (0.4 gal) |
Shipping Weight | 1,760 lb (798 kg) |
Net Weight | 1,585 (719 kg) |
Overall Dimensions (L x W x H) | 42 x |
The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Powermatic reserves the right to change specifications at any time and without prior notice, without incurring obligations.
7
