NOTE

This is a typical setup; your setup may vary.

Installation

1

Connect communication cable from computer to UPS (optional)

5

Press the button (on the front panel)

2 & 3

Connect UPS to power

4

Connect equipment to UPS

Figure 2. Typical UPS Installation (120V Model Shown)

3.Plug the UPS power cord into a power outlet.

4.Plug the equipment to be protected into the UPS output receptacles.

DO NOT protect laser printers with the UPS because of the exceptionally high power requirements of the heating elements.

5.Start the UPS by pressing the button as shown in Figure 2. The µindicator illuminates indicating that power is available from the UPS output receptacles.

The UPS conducts a self-test and enters Normal mode. If the alarm beeps or a UPS alarm indicator stays on, see Table 9 on page 28.

The installation is complete. To learn how to operate the UPS, see “Operation” on page 11.

NOTE The batteries charge to 90% capacity in approximately 3 hours. However, it is recommended that the batteries charge for 6 to 24 hours after installation or long-term storage.

Powerware® 5115 User’s Guide S www.powerware.com

5