Designing a Customized Course
The EC860 Professional Recumbent Cycle lets you design two custom courses: program “8” and program “9.” To access these courses, you need to press a specific combination of keys on the electronic console. This design helps secure the cycle from unauthorized access and changes.
To design a custom course, take the following steps:
1.Check that the cycle is turned ON. If it is turned OFF, turn it ON using the ON/OFF power switch. This switch is located on the front of the cycle, near the power cord.
2.Press the ON key. The initial
Note: If the cycle is already ON and EC860 is scrolling across the bottom of
the display. You can start pedaling, press the 
and 
keys, or press ENTER/RESET and the initial
3.Access the User Programming screen by simultaneously pressing and holding ON and 
for a minimum of 5 seconds.
4.Release both keys when you see the User Programming screen. In the upper
Note: User Program 1 represents program 8 and User Program 2 repre- sents program 9.
Diagram 4 | User Programming screen |
page 16
