7.Test the Hall 1 speed sensor by SLOWLY moving the pedals. Continue pedaling for about 1 minute. The asterisk to the right of “Hall 1” will blink on and off if the sensor is working correctly. If the asterisk stays solid, the cycle needs servicing. Please note that only Hall 1 is used; ignore Hall 2.
8.To exit the Diagnostic program, either use the power switch to turn the cycle OFF then ON, or press ENTER/RESET three times. In either case, the initial
Getting Service
Do not attempt to service an EC860 cycle yourself except for the maintenance and diagnostic tasks described in this manual. The EC860 cycle does not contain any
To contact a Precor Commercial Products Customer Service Representative, call
page 23
