Precor EFX 885, EFX 835 To tighten the fasteners properly, Center column support attachment

Assembling the EFX 21

Important: When wrench-tightening the screws, make sure the head of the fastener is parallel to the product surface. If it is not, stop tightening to avoid cross-threading. To avoid further damage, stop assembly work and contact Customer Support.

3.Check alignments and thread the remaining four center column support screws, four ⁵₁₆-inch washers, and four split washers. Tighten with a ³₁₆-inch hex key so the assemblies come together, but leave room for adjustments.

Figure 9: Center column support attachment

To tighten the fasteners properly:

CAUTION: Upright support fasteners must be properly aligned and wrench-tightened in the order described below. If improperly assembled, the upright supports can rub against the ramp.

1.Fully tighten the two sets of fasteners on the back of the center column support.

Figure 10: Tighten fasteners on back of the center column support