Assembling the EFX | 25 |
To attach the upright support covers and pivot arm caps:
1.Place one inner and one outer upright support cover around one of the upright supports, aligning them so that the arrows on their inside surfaces point toward the front of the unit.
2.Line up the protrusions on the outer cover with the screw holes on the inner cover.
3.Apply pressure to both covers so that the protrusions fit firmly into the screw holes.
4.Secure the upright support covers using two
Figure 18: Upright support cover attachment (right-hand cover shown)
5.Slide the covers down and snap them into the base mount.
Note: Be sure to align the covers so that the lip of each cover fits inside the edge of the base mount and the hook on the base mount fits into the corresponding slot on the cover. When you have snapped the covers into place, the surfaces of the covers and the base mount should line up smoothly.
6.Repeat steps 1 through 5 to attach the opposite pair of upright support covers.
