Photo 1

Handrail/display

 

assembly

Handrail/display assembly

Running bed

Handrail/display assembly mounts

 

3.

Remove the four 5/16" locknuts and washers (two on each side) from the

 

 

handrail/display assembly mounts near the front of the running bed as

 

 

shown in Photo 1.

 

4.

Position the handrail assembly so both the right and left handrail columns

 

 

align over the mounts. Replace the washers and locknuts. Using the hex

 

 

key provided in the hardware kit, securely tighten each locknut.

 

5.

Locate the ribbon cable connector that protrudes from the handrail/display

 

 

assembly.

 

 

 

Photo 2

Installing ribbon

 

 

 

cable connector

Printed circuit board

Ribbon cable receptacle

Ribbon cable connector

Handrail/display assembly

6.Align the tab on the side of the ribbon cable connector with its correspond- ing receptacle on the printed circuit board located near the motor. (See Photo 2.) Make sure that all pins are aligned and fully engaged. The connector is designed to engage in one direction only. Do not force the connector into the receptacle.

page 8

Page 8
Image 8
Precor M9.4 owner manual Handrail/display, Assembly, Installing ribbon Cable connector