Photo 3

Installing lift

 

motor

 

Lift motor

 

 

 

Lift motor support mount

7. Slide the lift motor into position, shaft side down, with the long tube toward the front of the treadmill and the short tube facing the treadmill motor. (See Photo 3.)

8. Secure the lift motor by placing one of the two hex-head shoulder bolts on

 

the 5/16" hex wrench (both are found in the hardware kit). Insert the bolt

 

through the lift motor mount and into the lift motor. Follow the same proce-

 

dure for the second shoulder bolt. (See Photo 3.) Align the motor and

 

securely tighten the shoulder bolts.

 

9. Locate the two plastic plug caps in the hardware kit. Insert the plastic plug

 

caps over the two shoulder bolts on the lift motor support mount.

 

 

 

 

Photo 4

Plug lift-motor

 

 

 

wiring harness

 

 

into printed circuit

 

 

board

 

 

Printed circuit

 

 

board

 

 

Lift motor wiring

 

 

 

 

 

 

harness

 

 

Lower board

 

 

 

 

 

 

chassis

 

 

 

 

 

 

10. Plug the lift-motor wiring harness into the receptacle on the printed circuit

 

board. (See Photo 4.)

 

11. Using the cable ties supplied in the hardware kit, secure the lift-motor

 

wiring to the lower board chassis. Cut the ends of the cable ties so the

 

excess plastic does not interfere with the motor or circuit board.

page 9

Page 9
Image 9
Precor M9.4 owner manual Installing lift, Motor, Lift motor, Plug lift-motor Wiring harness Into printed circuit Board