Assembling the AMT | 17 |
Required Tools
#2 Phillips screwdriver
Rubber mallet
SAE standard socket set
Wire cutter
Torque wrench (calibrated in
Performing the Assembly
DANGER Do not attempt to connect electrical power until all assembly procedures are complete and the console is properly installed.
Follow these steps to assemble the AMT base unit.
To begin assembly:
1.Remove the two side fasteners that hold the front frame tube to the shipping pallet and cut the tie wraps that secure the rear base.
CAUTION: Do not move the AMT off its shipping pallet without assistance. To avoid unnecessary movement of the foot plates, do not install the handlebars until you begin the next procedure.
2.Lift the rear base and roll the AMT forward while your assistant stabilizes the front base and guides it off the shipping pallet onto the floor.
Note: Begin assembly in the area intended for use.