20

Assembling and Maintaining RBK 800-Series Recumbent Exercise Bikes

6.Insert the two upright support mounting screws through the openings on the support and into the screw holes on the body assembly. Tighten the mounting screws completely using a ³₈-inch hex wrench.

Figure 7: Bolting the upright support into place

Important: In the following two steps, be extremely careful not to trap or pinch any of the cables between the bike frame and any of the covers.

7.Reposition the left side cover on the body assembly, then reattach and tighten the #10 x 1-inch self-tapping screws holding it in place.

8.Repeat the previous step to reinstall the rear and top covers.

Page 74
Image 74
Precor P30 Console manual Bolting the upright support into place