Prestigio P400MW, P460MW owner manual Connection of PC

Connection of PC

PC Setup

You can adjust horizontal/vertical position, clock, phase, and auto-configure, reset as you prefer.

Press the MENU button and then /\ / \/ button to select the SETUP menu.

Press the > button and then /\ / \/ button to select the desired picture item.

Press the < / > button to make appropriate adjustments.

H-Position / V-Position

This function is to adjust picture to left/right and up/down as you prefer.

Clock

This function is to minimize any vertical bars or stripes vis-ible on the screen background. And the horizontal screen size will also change.

Phase

This function allows you to remove any horizontal noise and clear or sharpen the image of characters.

Auto-configure

This function is for the automatic adjustment of the screen position, clock and phase. The displayed image will disap-pear for a few seconds while the Auto-configuration is in progress.

Reset

This function allows you to return to the good picture repro-duction programmed at the factory and cannot be changed.

Note : Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust your monitor’s position, clock and phase manually.

Press the OK button to store it for the PC monitor picture.

Press the EXIT button to return to PC mode.

WXGA (or VGA (Only RGB mode))

a : When the set is inputted WXGA signal, select the desired WXGA resolution.

b : When the set is inputted HDMI-480p signal in VGA mode, select 480p on the SETUP menu.

ENG

PRESTIGIO P400MW / P460MW 29