12 www.pridemobility.com Commander 400
LIFTING THE MOBILITY PRODUCT
WARNING! Before operating the lift
system for the first time, be
absolutely certain you have the
proper docking device for your
mobility product installed.
WARNING! Always operate the lift
and mobility device being lifted on
a flat, level surface
DOWN
UP
ROTATE LEFT ROTATE RIGHT
BOOM OUT*
BOOM IN*
* NO FUNCTION
ON 2-AXIS LIFT
Figure 7. Hand Control
POWER SWITCH OPERATION
The lift system is equipped with an ON/OFF switch
that enables/disables operation. Toggle the ON/OFF
switch to the “I” position to turn the power on; to the
“O” position to turn the power off. See figure 6.
NOTE: The ON/OFF switch also functions as the
circuit breaker reset button. See figure 6.
HAND CONTROL OPERATION
The hand control for the lift system operates the
arm in six directions: up/down, rotate left/right and
in/out. Press and hold the appropriate button until
the desired position is obtained. See figure 7.
NOTE: Store the hand control in the hand control
bracket (located on the boom) after operation and
during storage.
IV. OPERATION
1. Prepare your mobility product for transport. Ensure that the power is off and properly secure the
batteries. You may also need to lower the tiller and/or remove the seat.
2. Position your mobility product on the ground behind the installed lift. Be sure that there is ample space
between the mobility product and the vehicle bumper to ensure that the mobility product will not hit
the bumper while being raised. If the mobility product is too far from the vehicle’s bumper, the
mobility product will be dragged when attempting to lift it.
3. Position the boom-arm over the mobility product.
4. Operate the lift in the downward direction. The lift strap should drop straight down to the T-bar or
docking device collar.
WARNING! Inspect the lifting strap before each use for twisting, fraying, signs of wear,
loose parts, damage or debris. If you discover a problem, contact your authorized Pride
Provider for maintenance and repair.
WARNING! Avoid unloading into vehicular traffic.
NOTE: Keep tension on the lifting strap with your free hand when lowering the boom-arm.
WARNING! Do not extend the lifting strap past the warning label located on it.
Figure 6. ON/OFF Switch
ON/OFF SWITCH
OFF
ON