S t e a m e r 6 2 5 - A
Safety Information
WARNING
Indicates information important to the proper opera- tion of the unit. Failure to observe may result in dam- age to the equipment and/or severe bodily injury or death.
CAUTION
Indicates information important to the operation of the unit. Failure to observe may result in damage to the equipment.
Important
Prince Castle reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously pur- chased equipment.
Installation
Remove the unit from the carton and inspect for signs of damage. If there is damage to the unit:
•notify the carrier within 24 hours of delivery
•save carton and packaging materials for inspection purposes
•contact your local dealer, or if purchased directly, the Prince Castle Sales Department at
replacement unit.
WATER CONNECTION REQUIREMENTS
If this is a new installation, accessory -
NOTE: When installing this unit, the ambient temperature at the mounting site should not exceed 37.8°C (100°F) .
CAUTION
All electrical connections must be in accordance with local electrical codes and any other applicable codes.
Plug the unit into an applicable electrical receptacle. Connect the water line to the back of the unit.
CAUTION
Water connection must provide maximum water pressure of
Operation
1 | A. Turn unit power On/Off switch to ON position. The display |
flashes PRINCE CASTLE for ten seconds. | |
B. After ten seconds the display will show |
NOTE: The
indicating power is applied to the platen. Platen will heat to the setpoint temperature.
A. When the unit reaches the setpoint temperature, display will 2 show the product name assigned to button 1.
B. If 1 is the desired product to be steamed, pull out the spatula and place the product onto the spatula, cut side down.
Or
press product buttons 2, 3 or 4, then place product on the spatula, cut side down.
prince castle |
|
|
|
| |
|
|
|
Place the spatula fully into the unit and press the START button.
3 The display will start to count down the steam cycle.
When steam cycle is complete, the unit will sound a tone and
4 the display will flash REMOVE.
Pull out the spatula and remove the finished product.
8remove
Steamer | 2 | Printed in USA 0910 © 2003 |