Prince Castle 630-ROM4 manual Safety Information, Romar Pasta Cooker, Pre-Installation

Romar Pasta Cooker

630-ROM4

	Safety Information		Important!
	WARNING!	Prince Castle reserves the right to change specifications
		and product design without notice. Such revisions do
Indicates information important to the proper operation of
		not entitle the buyer to corresponding changes,
the unit. Failure to observe may result in damage to the
		improvements, additions or replacements for previously
equipment and/or severe bodily injury or death.
		purchased equipment.
	CAUTION!
Indicates information important to the operation of the
unit. Failure to observe may result in damage to the
equipment.
	Installation
	Pre-Installation		General Setup
Pre-installation is the responsibility of the user and should be		This unit is completely pre-wired and thoroughly tested prior to
completed prior to the shipment of the unit to the location.		shipment. All wiring and hookups shall be done without
•	Floor drain sink located no further than 10 ft. from the	opening the unit.
	intended location of the unit.	•	Place unit on the counter. The counter must be designed to fit
•	Electrical hookup box located no further than 5 ft. from the		the size and support the weight of the unit.
	intended location of the unit. The box should provide three	•	The unit must be level to insure proper function. To level the
	phase, 240 V protected with a three-phase 30-A breaker. All
			unit, use only the adjustable leveling feet (no shims or foreign
	terminals should be rated for gauge number 10-4 wire (L1-L2-
			objects).
	L3-Ground).
•	Dedicated water outlet with manual shut off valve no further	•	EPH require a minimum height of 4 in. between the counter
	than 7 ft. from the intended location of the unit. The water		and the unit.
	pressure should be at least 50 psi. The manual shut-off valve
	output has to accommodate ¾ in. NPT Hose connector.
•	Supporting counter with the minimum suggested dimensions
	of 24 in. high, 28 in. deep, and 44 in. wide. The counter must be
	capable of withstanding 340 lbs (weight of unit).
	Plumbing Connections
It is highly recommended that a licensed plumber install all		•	When connecting the steam generator blow-down outlet,
plumbing connections.			ensure that the valve (provided by Prince Castle) is reachable
All pre-installation and installation work must be in compliance			(arms length) from the front of the unit. The connecting “black
with national and local plumbing codes and health department			pipe” must be installed behind the unit and below the counter,
requirements.			away from easy reach. The blow-down piping must be
•	For standard water installation, connect per local plumbing		secured all the way to the floor sink.
		•	Do NOT reduce the blow-down outlet from its original size.
	codes.
•	The drainage from the unit to the floor sink is achieved by
	gravity only. Make sure that the 1” white PVC tubing is directed		Depending on local regulations, you may be required to
	downwards preventing any back-flow to the unit. Most local		install a second check valve or pressure reducing back-
	Health Departments require you to terminate the drainage tube		flow preventive device.
	4 in. above the highest point of the floor-sink.

Printed in USA 0404 © 2004 2 630-500