Prince Castle 630-ROM4 manual General Preparation & Operation, Electrical Connections

Romar Pasta Cooker

630-ROM4

Electrical Connections

WARNING!

SHOCK/DAMAGE HAZARD! No internal access is needed when wiring this unit. Substitution and/or modification of components and/or wiring system may void all warranties. Such practice may lead to dangerous operating conditions.

It is highly recommended that a licensed electrician install all electrical connections.

All pre-installation and installation work must be in compliance with national and local electrical codes.

•Power wiring must be installed in accordance with local and National Electric Code (N.E.C.) or Canadian electric code requirements.

•Before conducting field power connection, check to be sure that the field power conditions match with power requirements and rating specified on the unit nameplate on the back panel.

•As indicated in the Pre-Installation requirements, the user must provide a circuit breaker between the main power source and the unit. (Refer to nameplate for rating.)

•The unit is wired and tested by the factory to operate only with a single phase power configuration with one ground for main load and circuit control.

•To avoid severe electrical shock, provide grounding in accordance with N.E.C. requirements.

•When all the above steps are completed, place both hoppers on the rails and connect them.

General Preparation & Operation

1

Preparation of Pasta

Before loading the pasta into the unit, the long-cut	2	A.	Gently lift the pasta (as shown on left), letting it
pasta must be “feathered” by hand.			fall between your hands back into the bowl.
		B.	Repeat feathering several times, as necessary.
Ensure that your hands are clean before handling		The broken, unusable pieces that remain in the bottom
pasta.		of the bowl may be discarded.

Place long-cut pasta into a large bowl.

The feathered long-cut pasta is now ready to be cooked.

Procedure Complete

630-500 3 Printed in USA 0404 © 2004