ProForm 30777.0 user manual Handrail Bolts yet

8.With the help of a second person, press a Handrail Cap (21) onto the lower end of each Handrail (71) as shown. Next, set the Handrails on the Uprights (69) while sliding the Handrail Caps over the Handrail Brackets (5). Make sure that the Wire Harness (42) and the console wire are not pinched.

9.Finger tighten two Handrail Bolts (37) with two 1/4" Star Washers (95) into the Uprights (69) and the Handrails (71) as shown. Do not tighten the

Handrail Bolts yet.

Attach the lower ends of the Handrails (71) with 3/4" Screws (2). Then, tighten the two Handrail

Bolts (37).

10.Attach the Latch Housing (29) and the Latch Spacer (98) to the left Upright (69) with two 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (29), and tighten the knob onto the pin.

8
69	71
71
		42
21
		69
5
		21
	5
9
71
	37
95
	71	37
69		95
		69
2

		2
10
Large Hole
	98
	29	69
Knob
2		Collar
	Spring
		Pin

11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.

9