Remove the three #8 x 3/4" Screws (1) and care- fully pivot the Motor Hood (62) off.
62
1
Locate the Reed Switch (73) and the Magnet (47) |
|
|
on the left side of the Pulley (48). Turn the Pulley |
|
|
until the Magnet is aligned with the Reed Switch. |
|
|
Make sure that the gap between the Magnet and | 1/8 in. |
|
the Reed Switch is about 1/8 in. (3 mm). If neces- |
| |
sary, loosen the #8 x 3/4" Truss Head Screw (18), | 18 | 47 |
move the Reed Switch slightly, and then retighten | 73 | |
the Screw. Reattach the Motor Hood (not shown) | Top | 48 |
with the #8 x 3/4" Screws. Reattach the #8 x 2" |
| |
Screws if necessary. Run the treadmill for a few | View |
|
minutes to check for a correct speed reading. |
|
|
PROBLEM: The incline of the treadmill does not change correctly |
|
|
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The walking belt slows when walked on
SOLUTION: a. If an extension cord is needed, use only a | ||
than 5 ft. (1.5 m). |
|
|
b. If the walking belt is overtightened, treadmill perfor- | b |
|
mance may decrease and the walking belt may be- | ||
come damaged. Remove the key and UNPLUG |
| |
THE POWER CORD. Using the hex key, turn both |
|
|
idler roller bolts counterclockwise, 1/4 of a turn. |
|
|
When the walking belt is properly tightened, you |
|
|
should be able to lift each edge of the walking belt 2 |
|
|
to 3 in. (5 to 7 cm) off the walking platform. Be care- |
|
|
ful to keep the walking belt centered. Then, plug in |
|
|
the power cord, insert the key, and run the treadmill | Idler Roller Bolts | |
for a few minutes. Repeat until the walking belt is | ||
properly tightened. |
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual.
26
