HOW TO ADJUST THE DRIVE BELT
if you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted.
To adjust the drive belt, you must remove the top shield cap, the top shield, and the right shield (see the instructions below).
Using a flat screwdriver, remove the Top Shield Cap (10). Then, remove the two M4 x 16mm Screws (40) and lift the Top Shield (9) away from the frame.
40
Tip: It may be necessary to remove the right pedal.
Using an adjustable wrench, turn the right pedal coun- terclockwise and remove it.
Hold the two M8 Locknuts (37) and loosen the two M8 x 16mm Screws (53). Next, loosen the M10 x 50mm Screw (33) until the Drive Belt (23) is tight. Then, hold the M8 Locknuts and tighten the M8 x 16mm Screws.
Then, reattach the right shield, the top shield, and the top shield cap. Reattach the right pedal, if necessary.
Remove the five M4 x 16mm Screws (40) from the Right Shield (18). Then, gently move the Right Shield away from the frame.
2O
