,Orient the Console Plate (19) and the Handlebar
(47)as shown. Have a second person hold the Console Plate and the Handlebar near the
Upright (3).
Locate the Pulse Wire (52) in the Handlebar
(47). Insert the Pulse Wire into the hole in the Upright (3), and then pull it upward out of the top of the Upright.
Then, insert the Main Wire (31) and the Pulse Wire (52) upward through the Console Plate (19).
10.Tip: Avoid pinching the wires. Insert the Console Plate (19) into the Upright (3).
Attach the Handlebar (47) and the Console
Plate (19) to the Upright (3) with two M8 x 25mm Button Screws (44) and two M8 Split Washers (45).
3119
\
10
Avoid | pinching | 19 |
the | wires |
|
45
11. The Console (6) can use four D batteries
11
(not included); alkaline batteries are recom- mended, iMPORTANT: if the Console has
been exposed to cold temperatures, allow it to warm to room temperature before insert= ing batteries. Otherwise, you may damage the console displays or other electronic
components.
Remove the screws and the battery covers from the back of the Console (6), and insert batteries into the battery compartments. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. Then, reattach the battery covers.
To purchase an optional power adapter, call the telephone number on the cover of this manual. To avoid damaging the console, use
only a manufacturer=supplied power adapter. Plug one end of the power adapter into the receptacle on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances.
Battery Cover
6
\
y Cover
10
