ProForm 831.23745.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver , an adjustable

wrench , and a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is missing, call 1-888-533-1333.

M8 Nylon		M6 Split		M10 Spacer		M10 Split	Wave Washer
Locknut (96)–4		Washer (88)–8			(76)–2	Washer (72)–2	(93)–6
M4 x 16mm	M4 x 16mm		M4 x 16mm		M4 x 12mm
Screw (86)–4	Self-tapping		Flange Screw		Flange Screw
	Screw (79)–10		(84)–2		(73)–6
						M10 x 20mm x	M10 x 25mm x
	M4 x 65mm Screw (91)–4					2mm Washer	1.5mm Washer
						(81)–4	(83)–8
M6 x 16mm Phillips		M8 x 16mm Button		M8 x 42mm Button Bolt (71)–4			M10 x 23mm Shoulder
Screw (87)–8		Screw (95)–3					Screw (80)–8
M10 x 15mm Button		M10 x 48mm Button Screw (78)–2				M10 x 62mm Button Bolt (97)–2
Screw (82)–4
			M10 x 35mm Shoulder
				Screw (94)–2
					5