9.While another person holds the Upright (11) in the position shown, connect the console wire to the Reed Switch Wire (46). Next, connect the console cable to the Lower Cable (32) in the following way:
•Refer to inset drawing A. Pull up on the metal brack- et on the Lower Cable (32), and insed the tip of the
console cable (CC) into the wire clip inside of the metal bracket.
•Refer to inset drawing B. Firmly pull the console cable (CC) and slide it into the metal bracket on the Lower Cable (32) as shown.
•Refer to inset drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.
Insert the excess wire and cable down into the Frame
(1). Slide the Upright (11) onto the Frame. Make sure
that the wires and cables are not pinched. Attach the Upright to the Frame with two MIO x 66ram Button
Bolts (47), two MIO Split Washers (43), and two MIO
Nylon Locknuts (44).
10.Identify the Left Pedal (20), which is marked with an
"L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the left arm of the
Crank (14). Tighten the Right Pedal (not shown) clock- wise into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened.
Adjust the left Pedal Strap (21) to the desired position, and press the end of the Pedal Strap onto the tab on the side of the Left Pedal (20). Adjust the other Pedal Strap (not shown) in the same way.
:9
Console Wir? "_''/-
_'/_ | Co_ns: 4 Cable |
A
Metal +
Bracket r_( I
J Bracket
Metalf i
32_
10 f
11.Make sure that all parts of the exercise cycle are properly tightened. Note: Some hardware may be left over after assembly is completed, To protect the floor or carpet from damage, place a mat under the exercise cycle.
