Gateway EC58 Xxxi, No-beep Error Message List, No-beep Error FRU/Action in Sequence Messages

		www.gateway.com
No-beep Error Message List
No-beep Error	FRU/Action in Sequence
Messages
No beep, power-on	■	Test the power source (battery pack and power adapter). See “Power System
indicator turns off and		Check” on page xxvi.
LCD is blank.	■	Make sure that every connector is connected tightly and correctly.
	■	Reconnect the DIMM.
	■	Test or replace the LED board.
	■	Test or replace the system board.

No beep, power-on indicator turns on and LCD is blank.

■Test the power source (battery pack and power adapter). See “Power System Check” on page xxvi.

■Reconnect the LCD connector

■Check the hard disk drive.

■Check the LCD inverter ID.

■Check the LCD cable.

■Test or replace the LCD inverter.

■Test or replace the LCD.

■Test or replace the system board.

No beep, power-on	■	Reconnect the LCD connectors.
indicator turns on and	■	Check the LCD inverter ID.
LCD is blank. But you	■	Check the LCD cable.
can see POST on an	■	Test or replace the LCD inverter.
external CRT.	■	Test or replace the LCD.
	■	Test or replace the system board.
No beep, power-on	■	Make sure that every connector is connected tightly and correctly.
indicator turns on and	■	Test or replace the system board.
a blinking cursor
shown on LCD during
POST.
No beep during POST	■	Test or replace the speaker.
but system runs	■	Test or replace the system board.
correctly.

xxxi