ASSEMBLY
Assembly requires two persons. Place all parts of the PROFORM¨ REBEL in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver 
, two adjustable wrenches 
and a
rubber mallet 
(none of these are included).
1.Hold the Stabilizer (68) against the saddle on the back of the Base (1). Attach the Stabilizer with two M10 x 75mm Bolts (66) and two M10 Nylon Locknuts (54).
2.Slide the Rail Stabilizer (37) onto the Base (1), so the
Insert two M10 x 68mm Bolts (67) with two M10 Washers (71) up through the Base (1).
Insert two M10 x 68mm Bolts (67) with two M10 Washers (71) up through the Rail Stabilizer (37).
Note: It may be easier to insert the four Bolts by tipping the unit on its side.
3.While one person holds the Upright (2), connect the Extension Wire (49) coming from the Upright to the Reed Switch Wire (48) extending from the Base (1).
Stuff any excess wire into the Upright or into the Base
(1).
Slide the Upright (2) onto the four M10 x 68mm Bolts (67). Make sure you donÕt damage the wires as you slide the Upright into place.
Hand tighten an M10 Nylon Locknut (54) onto each M10 x 68mm Bolt (67). Tip the unit on its side and use two wrenches to tighten the Locknuts fully.
1 | 54 |
| 1 |
54 |
|
| 68 |
| 66 |
2 |
|
37 | |
| 48 |
| 71 |
67 | 1 |
3 |
|
54 | 54 |
| |
2 |
|
| 49 |
| 48 |
| 1 |
67 |
|
5
