Speed, time, distance, fat calorie or calorie modeÑTo select one of these modes for continu- ous display, press the mode button repeatedly. The mode indicators will show which mode is selected. (Make sure that the scan mode is not selected.)
3. To reset the display, press the on/reset button.
4.The console has an
MAINTENANCE
CONSOLE TROUBLE-SHOOTING
If the console does not function properly, the batteries should be replaced. To replace the batteries, see assembly step 10 on page 8. In addition, make sure that the console wire is connected to the seat bar wire. See assembly step 5 on page 6.
HOW TO REMOVE THE SIDE SHIELDS
For all of the following steps, one or both Side Shields (11 and 27) must be removed.
To remove the Left Side Shield (11), unscrew the 1/2Ó Nylon Locknut (9) and remove the Pedal Bolt (8) and the Plastic Pedal Spacer (42) from the Left Pedal Leg
(3). Unscrew the seven M4 x 38mm Screws (4) from the Left Side Shield. Gently pull the Left Side Shield out and to the side, so the Crank Arm (10) fits through the hole in the Side Shield.
To remove the Right Side Shield (27), first remove the Left Side Shield (11) as described above. Then
unscrew the three M4 x 38mm Screws (4) from the lower edge of the Right Side Shield. Remove the 1/2Ó Nylon Locknut (9), Pedal Bolt (8) and Plastic pedal Spacer (42) from the Right Pedal Leg (70, not shown). Gently pull the Right Side Shield over the Crank Arm.
|
|
| 11 | 4 |
|
|
|
| 27 |
| 4 |
|
| 4 |
|
|
|
| |
|
| 42 |
| 9 |
|
|
|
| |
3 |
|
|
| 10 |
|
|
|
| |
|
|
|
| 4 |
| 8 | 4 |
|
|
|
|
|
| |
10 |
|
|
|
|
