8.While another person holds the Upright (6) in the position shown, connect the Extension Wire (18) to the Wire Harness (69).
Next, carefully slide the Upright (6) onto the Frame
(1).Be careful to avoid pinching the wires.
Loosely thread four M10 x 25mm Button Screws
(74)with M10 Split Washers (17) into the Upright and the Frame. Then, firmly tighten all four Button Screws.
9.While another person holds the Handlebar (16) near the Upright (6), route the two Pulse Wires (22) into the Upright and out of the hole at the top of the Upright.
Next, attach the Handlebar (16) to the Upright (6) with two M10 x 25mm Button Screws (74) and two M10 Split Washers (17). Make sure that the Pulse
Wires (22) are not pinched between the Handle- bar and the Upright.
10.Hold the Console (9) near the Upright (6) as shown. Identify the green console ground wire and attach it to the Upright with a Ground Screw (82). Make sure that the console ground wire connector is pointed toward the center of the indicated hole as shown.
Next, connect the Extension Wire (18) and the two Pulse Wires (22) to the corresponding wires on the Console (9). Make sure that the wires are not tan- gled around each other.
11.Attach the Console (9) to the Upright (6) with the four Console Screws (20). Make sure that no wires are pinched between the Console and the Upright.
8
8 |
|
|
|
|
| 6 |
|
|
| 17 |
|
74 |
| 17 | 74 |
| 1 | 18 |
|
|
|
| |
|
| 69 |
|
9 |
|
|
|
|
|
| 16 |
6 |
| 22 |
|
|
|
| 17 |
|
| 17 | 74 |
10 |
|
|
|
|
| Console |
|
| 18 | Wires |
|
|
|
| |
6 |
|
|
|
|
| 22 |
|
|
| 82 | 9 |
|
|
| |
Hole |
| Console | |
|
| ||
|
| Ground | |
|
| Wire | |
11 |
|
|
|
|
|
| 9 |
20 |
|
|
|
20 | 6 |
|
|
|
|
| |
