PROBLEM: The walking belt is off-center or slips when walked on

 

 

 

 

SOLUTION: a. If the walking belt is off-center, remove the key and

 

 

 

 

UNPLUG THE POWER CORD. If the walking belt

 

a

 

has shifted to the left, use the hex key to turn the

 

 

 

 

 

 

 

 

left idler roller bolt clockwise 1/2 of a turn; if the

 

 

 

 

walking belt has shifted to the right, turn the left

 

 

 

 

idler roller bolt counterclockwise 1/2 of a turn. Be

 

 

 

 

careful not to overtighten the walking belt. Plug in the

 

 

 

 

power cord, insert the key, and run the treadmill for a

 

 

 

 

few minutes. Repeat until the walking belt is cen-

 

 

 

 

tered.

 

 

 

 

b. If the walking belt slips when walked on, first remove

 

 

 

 

the key and UNPLUG THE POWER CORD. Using

 

b

 

the hex key, turn both idler roller bolts clockwise, 1/4

 

 

 

 

of a turn. When the walking belt is correctly tight-

 

 

 

 

ened, you should be able to lift each edge of the

 

 

 

 

walking belt 3 to 4 in. (8 to 10 cm) off the walking

 

 

 

 

platform. Be careful to keep the walking belt cen-

 

 

 

 

tered. Then, plug in the power cord, insert the key,

 

 

 

 

and carefully walk on the treadmill for a few minutes.

 

 

 

 

 

 

 

 

Repeat until the walking belt is properly tightened.

 

 

 

 

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The console display has lines running through it

SOLUTION: a. If lines appear in the console display, see THE INFORMATION MODE on page 18 and adjust the contrast level of the display.

23

Page 23
Image 23
ProForm Not AvailablePFTL13810.0 Unplug the Power CORD. If the walking belt, Key and Unplug the Power CORD. Using