11.Apply a small amount of grease to the axle on the left Crank Arm (6).
Slide a Nylon Washer (11) and the Left Pedal Arm (3) onto the axle on the left Crank Arm (6). Note: It may be helpful to use a rubber mallet to tap these parts on. Be careful not to confuse the Left Pedal Arm with the Right Pedal Arm (not shown); look at the position of the round tube to identify the Left Pedal Arm.
Next, tap a 3/4Ó Axle Cap (61) onto the axle.
Attach the Right Pedal Arm (not shown) in the same way.
12.Refer to the inset drawing. Apply a small amount of the included Teflon¨ lubricant to a paper towel; rub a thin film of the lubricant onto each of the Chrome Tubes (21). Slide an Upper Body Arm (7) onto each Chrome Tube. Make sure that the Upper Body Arms are turned as shown.
Tap a 5/8Ó Axle Cap (85) onto one end of the Axle (19). Insert the Axle through one of the Upper Body Arms (7) and then through the Upright (2). Slide the other Upper Body Arm (7) onto the Axle. Tap another 5/8Ó Axle Cap (85) onto the Axle.
11
Grease |
3 | 6 |
|
61
11
Round Tube 
12
| 7 | ||||
85 |
|
|
|
| |
21 | |||||
| |||||
|
|
|
| Lube | |
|
|
|
| ||
|
|
|
| ||
19 | 4 | ||||
85 | 7 |
|
2
7
13.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.
9
