3.Lay a cloth over the front of the Frame (1) to protect it. Lay the Upright (2) in the position shown. Connect the Extension Wire (51) to the Reed Switch Wire (50).
Next, connect the Resistance Cable (57) to the Extension Cable (84) in the following way:
¥Refer to drawing A. Pull up on the metal bracket, and insert the tip of the Resistance Cable (57) into the wire clip on the Extension Cable (84) as shown.
¥Refer to drawing B. Firmly pull the Resistance Cable (57) and slide it into the metal bracket on the Extension Cable (84) as shown.
¥Refer to drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.
4.Align the two holes in the front of the Upright (2) with the two welded bolts on the front of the Frame (1). Carefully push the Reed Switch Wire (not shown) into the Upright until there is no slack.
Next, pivot the Upright (2) about halfway to the vertical position while guiding the metal bracket on the Extension Cable (not shown) into the Upright. Once the top edge of the metal bracket is inside the Upright, pivot the Upright to the vertical position so it rests on the four welded bolts on the Frame (1). Be careful to avoid pinching the wires. Tighten a M10 Nylon Locknut (26) onto each welded bolt.
Refer to assembly step 2. Insert the tab on the Resis- tance Control (57) into the Upright (2). Next, press the bottom of the Resistance Control against the Upright.
Tighten the M4 x16mm Screw (35) into the Resistance Control and the Upright.
5.Attach the Incline Bracket (24) to the lower end of the Upright (2) with the M10 x 85mm Bolt (25) and an M10 Nylon Locknut (26). Do not overtighten the Nylon
Locknut; the Incline Bracket must pivot easily.
32
57
51
84
1 50
A | B | C |
Metal | 57 |
Bracket |
|
57
57 |
84 | 84 | 84 |
4
26
2 |
Welded
Bolts
1
5
24
2
26
25
6
