6.Slide an M8 Split Washer (58) and an M8 Washer (81) onto an Axle Screw (30). Tighten the Axle Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline Axle.
Align the indicated tubes on the Incline Frame (5) with the tubes on the Base (1). Make sure that the Incline
Frame is turned so the
Slide an M8 Split Washer (58) and an M8 Washer (81) onto the other Axle Screw (30). Tighten the Axle Screw into the open end of the Incline Axle (29).
6
| 5 |
| 58 |
| 81 |
1 | 30 |
| |
Grease | Tubes |
81
58
29 | Tubes |
|
30
7. The Console (87) requires two ÒAAÓ batteries (not |
included). Alkaline batteries are recommended. To |
install batteries, turn the console over and insert two |
batteries into the battery clip as shown in the inset |
drawing. Make sure that the negative ends of the |
batteries (marked ÒÑÓ) are touching the springs in |
the battery clip. |
Attach a Plastic Tie (53) to the battery clip as shown. |
Attach the Console (87) to the Console Base (49) with |
four M4 x 16mm Screws (35), making sure that the |
indicated wires are extending from the Console Base |
(49). Be careful not to pinch the wires. |
8. Connect the Extension Wire (51) to the corresponding |
787
49
Wires
Batteries
53
Battery
Clip
35
wire on the Console (87). |
Next, connect the two Pulse Wires (86) to the two |
remaining wires on the Console (87). Note: Either |
Pulse Wire can be attached to either wire on the |
Console. |
Next, connect the ground wire to the indicated hole in |
the Upright (2) with an M4 x 16mm Screw (35). |
Carefully feed the wires down into the Upright (2). |
8
Console
Wires
86
51 
87
49
35
Ground Wire
Attach the Console Base (49) to the Upright with four |
M4 x 16mm Screws (35). Be careful to avoid pinch- |
ing the wires. |
35 |
35 
2
7
