ProForm PFEL45010 user manual Assembly, Wrench A rubber, MI0

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included	allen	wrenches, assembly	requires a phillips	screwdriver __,		an adjustable
wrench	__	, and a rubber	mallet ¢	I_	I °
				1=	)

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assembledfor shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

', . .... J"

M8 Nylon	M10 Nylon		MI0	Split	Handlebar	M10
Locknut (38)-4	Locknut (33)---4		Washer	(59)-6	Washer (55)-2	Washer(78)=2
							\
Lz				Lii ii
M4 x 16mm						\
Screw (52)-2	M6 x 25mm	M8 x 19mm Button			M10 x 27mm
	Screw (7)-1		Screw (56)-2		Pedal Bolt (80)-2	Spring	Bracket
						Washer	(35)-2
			/
							i
	i /						_ j	J
							_	/
							i	..J

M8 x 45ram Button Screw (50)---4

\

/

[ ./

M I 0 x 27mm	M I 0 x 27mm
Patch Screw (40)-2	Screw (67)-6

1.Identify the Front Stabilizer (10), which has Wheels (22) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 75mm Carriage Bolts (34) and two

M10 Nylon Locknuts (33). Make sure that the Front Stabilizer is turned so the Wheels are not touching the floor,

MI 0 Bolt Set (74)-2

/

M10 x 75mm Carriage Bolt (34)---4

22

34

22

34

1033