ProForm PFEL45010 user manual Ment. Make sure that the batteries are oriented as

2.WhileanotherpersonliftsthebackoftheFrame(1),

attachtheRearStabilizer(9)totheFramewithtwo M10x 75mmCarriageBolts(34)andtwoM1ONylon Locknuts(33).

3.WhileanotherpersonholdstheUpright(2)intheposi- tionshown,connecttheExtensionWireHarness(44) to theWireHarness(79).Carefullypullthe upper

end of the Extension Wire Harness to remove any slack. While holding the upper end of the Extension Wire Harness, insert the Upright into the Frame (1). Do not pinch the Wire Harnesses.

Next, turn the Upright Knob (43) counterclockwise sev- eral turns. Pull the Knob, slide the Upright (2) down until the Knob is aligned with one of the four adjust- ment holes, and then release the Knob. Do not tighten the Knob yet.

33

9

Make sure the

Wire Harnesses

(44, 79) do not get pinched and damaged during

'i_i 59 67 this step.

Feed the upper end of the Extension Wire Harness (44) through the Upright Extension (73). Attach the Upright Extension to the Upright (2) with three M10 x 27mm Button Screws (67) and three M10 Split Washers (59).

4. Connect the wire harness on the Handgrip Pulse

Sensor (29) to the indicated wire harness on the

Console (23). Insert both wire harnesses into the open-

ing in the bottom of the Console. Next, insert the metal

tube on the Handgrip Pulse Sensor into the opening in

the bottom of the Console. Be careful not to pinch

the wire harnesses.

Refer to the inset drawing. Align the holes in the brack-

et on the Console (23) with the holes in the metal tube

on the Handgrip Pulse Sensor (29). Tighten two M4 x

16mm Screws (52) through the bracket into the tube as

shown.

23

43

29

Bracket

Tube

Tube

29

5. The Console (23) requires four "D" batteries (not

included); alkaline batteries are recommended. Press

the tab on the battery cover, and lift off the battery

cover. Insert four batteries into the battery compart-

ment. Make sure that the batteries are oriented as

shown by the diagram inside the battery compart-

ment. Reattach the battery cover.

Wire Harnesses

Battery _ -_ _z--jTab

Cover /"-_

Batteries,

23

6