ProForm PFEL54930 user manual Make sure that, Apply a generous amount of grease to the Pivot Axle

® lubricant

9. Apply a small amount of the included Teflon

to a paper towel. Rub a thin film of the lubricant onto

the Handlebar Legs (79).	Next, identify the Left
Handlebar (9) and the Right Handlebar (10), which are
marked with stickers. S	lide the Left Handlebar onto the
left Handlebar Leg, and slide	the Right Handlebar onto
the right Handlebar Leg.	Make sure that the

Handlebars are on the correct sides—the upper ends should bend in the direction shown.

Apply a generous amount of grease to the Pivot Axle

(88). Insert the Pivot Axle through the Right Handlebar (10), a Handlebar Spacer (25), and an Upright Spacer

(26)as shown. Next, insert the Pivot Axle into the Upright (2) until the left end of the Pivot Axle is flush with the left side of the Upright. Then, insert the Pivot Axle through the other Upright Spacer (26), the other Handlebar Spacer (25), and the Left Handlebar (9).

Slide an M10.3 Black Washer (53) onto an M8 x 19mm Shoulder Screw (22). Attach a Handlebar Cap

(23)to one end of the Pivot Axle (88) with the Shoulder Screw. Attach the other Handlebar Cap to the other end of the Pivot Axle in the same way.

Tighten both Shoulder Screws at the same time.

10.Attach the Water Bottle Holder (91) to the Upright

(2)with two M4 x 22mm Screws (93).

9
			10
			Grease	22
			53
			88
			23
9	26		25
25			26
23			2
22		79
			Lubricant
53			79
Lubricant
10
			91
			93
			2

8