MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 12 on page 11 for replacement instructions.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper- ly, see step 5 on page 16.
HOW TO ELIMINATE FLEXING IN THE CENTER OF THE ELLIPTICAL EXERCISER
Next, locate the |
| |
Reed Switch (50). | 40 | |
Turn the Pulley |
| |
(40) until a Magnet |
| |
(55) is aligned with | 50 | |
the Reed Switch. | 55 | |
Loosen, but do not | ||
103 | ||
remove, the indi- | ||
| ||
cated M4 x 16mm |
| |
Screw (103). Slide |
| |
the Reed Switch |
|
slightly closer to or
away from the Magnet, and then retighten the Screw. Rock the Pulley forward and backward just enough that the Magnet passes the Reed Switch repeatedly. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shields, the crank arms, and the link arms. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24.
HOW TO ADJUST THE BELT
If the elliptical exer- ciser flexes in the center during use, turn the base foot until the flexing is eliminated.
Base |
Foot |
If you can feel the pedals slip while you are pedaling, even when the resistance of the pedals is at the high- est setting, the Belt (51) may need to be adjusted.
First, see step 11 on page 10 and remove the link arms. Next, see step 4 on page 7 and remove the crank arms.
Then, remove all the screws from both side shields; there are three sizes of screws in the side
HOW TO LEVEL THE ELLIPTICAL EXERCISER
away from the frame.
If the elliptical exerciser rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL EXERCISER on page 12.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. First, see step 11 on page 10 and remove the link arms. Next, see step 4 on page 7 and remove the crank arms.
Then, remove all of the screws from both side shields; there are three sizes of screws in the side
Next, tighten the |
| |
M8 x 35mm Screw |
| |
(96) until the Belt | 51 | |
(51) is tight. Then, | ||
| ||
reattach the side |
| |
shields, the crank |
| |
arms, and the link |
| |
arms. Note: If you |
| |
have questions as | 96 | |
to which screw |
| |
should be in which |
| |
hole, see |
|
EXPLODED DRAWING B on page 27 and the PART LIST on page 24.
19
