ProForm PFTL06009.0 user manual With a second Bolt Spacer 82, 3/8 x 4 Bolt, 3/8 Star Washer

3. Identify the Right Upright (77) and the Right	3
Upright Spacer (88), which are marked with
“Right” stickers. Insert the Wire Harness (87)				77
through the Right Upright Spacer as shown.	87
Then, set the Right Upright Spacer on the Base
(84).		Wire Tie		88		87
Have a second person hold the Right Upright
(77) near the Base (84). See the inset drawing.						84
Tie the wire tie in the Right Upright securely
around the end of the Wire Harness (87). Then,
pull the other end of the wire tie until the Wire
Harness is routed completely through the Right		77
Upright.
	87	Wire
		Tie
4. Hold a Bolt Spacer (82) inside the lower end of	4
the Right Upright (77). Insert a 3/8" x 4" Bolt (4)				4
with a 3/8" Star Washer (8) into the Right		77
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (82), 3/8" x 4" Bolt				887
(4), and 3/8" Star Washer (8).
Hold the Right Upright (77) against the Right						82
Upright Spacer (88). Be careful not to pinch
the Wire Harness (87). Tighten the 3/8" x 4"
Bolts (4) until the heads of the Bolts touch the				82		80
Right Upright; do not fully tighten the Bolts
yet.				88
Press a Base Cap (80) into the Base (84).				84
5. With the help of a second person, carefully tip	5	A
the treadmill onto its right side. Partially fold the			B
Frame (52) so the treadmill is more stable; do
not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Attach a Wheel (85) to the Base (84) with a
3/8" x 2" Bolt (6) and a 3/8" Nut (7). Do not					6
overtighten the Nut; the Wheel must turn						52
freely.
			84	85	7
	8