34.Upon completion of any service or repairs to the treadmill or the television, ask the ser- vice technician to perform safety checks to confirm that the unit is in proper operating condition.
35.Use No. 10 AWG (5.3 mm2) copper, No. 8 AWG (8.4 mm2) aluminum, No. 17 AWG (1.0 mm2)
36.Secure an antenna
37.Mount an antenna discharge unit as close as possible to where the
38.Use a jumper wire not smaller than No. 6 AWG (13.3 mm2) copper, or the equivalent, when a separate
39.Note to CATV system installer: This reminder is provided to call the CATV system install- er’s attention to Article
Power Lines |
| Ground |
| |
|
| Standoff | ||
|
| Clamp | ||
|
|
| Insulators | |
Service |
|
|
| |
Entrance | To External 75 Ohm | Mast | ||
Conductors | Terminal of Treadmill | Antenna | ||
|
|
| ||
Service |
|
| ||
Entrance |
| Ground | Antenna | |
Equipment |
| Wire | Discharge Unit | |
Power Service Grounding |
|
| Ground Wire | |
Ground | Bonding | Ground | ||
Electrode System (e.g. | ||||
Interior Metal Water Pipe) | Clamps | Jumper | Clamps | |
|
| Optional Antenna Grounding Electrode Driven 8 | ||
|
| Feet (2.44 m) Into The Earth (If Required By Local | ||
|
| Codes). See NEC Section |
SAVE THESE INSTRUCTIONS
5