5.Insert the Wire Harnesses (77, 78) down into the right Upright (84).
Set the console assembly on the Uprights (84). Be care- ful to avoid pinching the Wire Harnesses (77, 78). While a second person holds the console assembly, at- tach it with four Console Bolts (64) and four Star Washers
(8) as shown; start all four Console Bolts and then firmly tighten them.
6.Attach the Latch Housing (73) to the left Upright (84) with two Screws (3); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two col- lars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob onto the pin.
Plug in the power cord as described on page 10, and turn on the power as described on page 12. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level.
7.Place the treadmill in the storage position (see HOW TO FOLD AND MOVE THE TREADMILL on page 20).
Next, place the cylinder end of the Gas Spring (92) near the bracket on the base of the Uprights (84).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Spring Pin (25) to loosen it from the Gas Spring (92). Next, rotate the Spring Pin and pull it out of the Gas Spring. Be careful to avoid losing the Spring Pin. Note: Extra Spring Pins are included.
See drawing 7a. Press the cylinder end of the Gas Spring (92) onto the ball on the bracket. Next, insert the end of the Spring Pin (25) into two of the small holes in the end of the Gas Spring. Then, rotate the Spring Pin until it clips onto the Gas Spring.
5
Console
Assembly 
| 77, 78 |
|
|
|
| 8 |
|
|
|
| 64 |
| 8 |
|
|
| 64 |
| |
| 84 |
|
| |
|
| 84 |
| |
|
|
|
| |
6 |
|
|
|
|
|
|
| 73 |
|
|
|
| Spring |
|
Knob | 3 |
| Pin |
|
Large |
|
| ||
|
| 84 | ||
|
| Hole | Collar |
7 |
| 25 |
|
| |
| 84 |
|
|
| 25 |
| 92 | Bracket |
|
| |
|
| 25 |
|
| Cylinder |
7a |
|
|
| 25 |
|
92 |
| Bracket |
8
