Proxim 70443r2 manual PRE-ASSEMBLE Hardware, Pre-Assemble Mounting Hardware

Tsunami QuickBridge II T1/E1 Quick Install Guide

STEP 3. PRE-ASSEMBLE HARDWARE

Proxim recommends that you pre-assemble the radio mounting hardware on the ground to familiarize yourself with the equipment and check for any possible damaged or missing components before mounting the radios. This includes attaching the mounting bracket and loosely attaching the washers, lock washers, and lock nuts to the radios. Installers having prior installation experience may choose to skip this step and proceed with Step 3.

•For outdoor installation, the Tsunami QuickBridge II package includes a CAT 5e cable. This is a higher grade than a standard cable.

•For indoor installation, use either a standard CAT 5e or a CAT 5 cable when connecting to the PC.

Pre-Assemble Mounting Hardware

Perform these steps on each radio to pre-assemble the mounting hardware on the radios: 1. Place mounting bracket onto mounting hole on rear of radio unit; insert mounting screw

2. Screw locking bolt onto mounting screw.

3.Raise mounting bracket to proper angle and tighten carriage bolt. Use a nut driver or socket wrench to firmly tighten the carriage bolt.

Copyright © 2005 Proxim Corporation. All rights reserved. 4