PSC PowerScanTM RF , Using the PowerScan RF System

User’s Guide

Using the PowerScan RF System

This section covers the following topics:

• Battery Charging and Maintenance

•How to Scan

• LED and Beeper Indications

Seat the scanner in the Base Station as shown in Figure4, ensuring

that the battery fully engages the station’s metal contacts. The

CHARGE LED on the Base Station should flash, indicating the bat-

tery is charging.

NOTE

When the scanner is in use, a low battery condition

is indicated by a repeated two-flash signal from the

scanner’s green LED every time the trigger is pulled

before the laser is enabled. This indicator may have

been disabled via custom programming. See

for more information.

Contents

Main Page i Table of Contents Users Guide 1 Unpack and Inspect Your Scanner References Quick Start Instructions Installing the Battery Figure 1. Installing the Battery Battery Charging and Maintenance Page Figure 3. Connecting Power to the Base Station References Linking the Scanner to a Base Station Configurator Express Verifying Scanner-to-Base Station Communications Using the PowerScan RF System Battery Charging and Maintenance Figure 4. Charging the Battery LED and Beeper Indications Tips for Extending Battery Life Disposing of Batteries Four Station Charger Figure 5. Using the Four Station Charger Accessory How to Scan Figure 6. Scanning Tips Depth of Field Figure 7. Depth of Field (SR) Depth of Field Figure 8. Depth of Field (HD) Depth of Field Figure 9. Depth of Field (LR) Depth of Field Figure 10. Depth of Field (XLR) Depth of Field LED and Beeper Indications Page . Page Active Symbologies Enhanced Scanning for Hard-to-Read Bar Codes Figure 11. Scanner Labeling and Nomenclature Laser Cautions Radio Frequency Interference Page 24 Scanner Troubleshooting Sample Bar Codes 14476925 1 2 3 4 5 6 7 8 9 0 1 101234 567891 Page DECLARATION OF CONFORMITY www.pscnet.com