PYLE Audio SLV5400 Interference, Image on TV2, Restrict the distance, Video sources, From TV2

Troubleshooting

Problem Tip

Interference in the •		Slightly change the position of the
image on TV2	•	receiver (B) or the transmitter (A).
		Change the wireless channel that
		is used for communication. See
	•	page 7.
		The receiver (B) is out of range of
		the transmitter (A). The number
		of walls and ceilings in between
		the receiver (B) and transmitter
		(A) restrict the distance.
The video sources •		Point the remote control directly
do not respond to	•	to the receiver (B).
the remote con-		Replace the batteries of the
trol commands	•	remote controls with new ones.
from TV2		Install the remote control blaster
	•	cord (G). See page 6.
		The maximum operating distance
		of the remote control is 5 m.
The image of the	•	Turn off the auto standby mode
video source dis-		of the video source. See its user
appears on TV2	•	manual.
		Follow the instructions to recon-
		nect the video sources. See the
		quick start guide.
Buzzing sound	•	Slightly change the position of the
when you use the		receiver or the transmitter until
remote control.	•	the buzzing sound stops.
		Sometimes it is not possible to
		solve the problem.
Black and white	•	Check if the SCART connector of
image with S-VHS		the S-VHS VCR gives signal in
VCR.		CVBS. See its user manual.
Cannot record a	•	Check if you used full-wired
DVD or video	•	SCART cables.
tape.		DVD or video tape is copyright
		protected.

EN

11