B – Command Line Interface
Set Config Command
59021-06 A B-35
D
zoning
Initiates an editing session in which to change switch zoning attributes. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table B-12. Set Config Zoning Parameters
Parameter Description
FC-SW-2 AutoSave Available only when the FC-SW-2
Compliant parameter is True, this
parameter enables (True) or disables
(False) the saving of changes to active
zone set in the switch’s permanent
memory. Refer to ”FC-SW-2
Compliant” on page B-33. The default is
True.
Default Enables (All) or disables (None)
communication among the switch’s
ports/devices and the fabric in the
absence of an active zone set. The
default is All.