Q-See DVR Setup 5.2 Camera Select, DVR Setup 5.3 Record Select, DVR Setup 5.4 Record Mode

Q-See Q25DVR4ES User's Manual

Chapter 5: DVR Setup - 5.2 Camera Select

The DVR system can display 4 camera feeds in one picture (Quad Mode).

Users can configure which camera is displayed.

Press [	Select] to modify setting and press [ CH1],
[ CH2], [ CH3],[		CH4] to set each channel
separately.
If the channel is disabled, the system will display
OFF	on the monitor.

Chapter 5: DVR Setup - 5.3 Record Select

Configure which channels are allowed to record.

Note: If no channels are selected, an error message will appear briefly on the screen when record is selected.

Chapter 5: DVR Setup - 5.4 Record Mode

There are two modes of resolution for video recording

1.Each Mode: The DVR compresses and records each video channel separately so the user can enlarge a single channel to full screen display and still be recording on all channels. You can also record on specific channels, for example, user can turn off the record function of CH1 and CH2 and then the system will only record video on CH3 and CH4.

Press [ CH1], [ CH2], [ CH3], [ CH4] to switch between channels when playing back recorded video.

In Each Mode user can use the Loop Function.

Loop Function: When the system is in Live mode or Recording mode,press the

Q-See Q25DVR4ES User's Manual

SEARCH TIME

			1			2
2008/01/08			08:30:56	2008/01/08		16:00:35
3	01	TIME		2008/01/08	15:50:20
	*02	TIME		2008/01/08	14:30:56
	03	TIME		2008/01/08	14:15:30
	*04	TIME		2008/01/08	14:00:15
5	*05	MOTION		2008/01/08	13:55:37
	0 6 MOTION			2008/01/08	11:30:12
4	07	MOTION		2008/01/08	10:15:30
	08	MOTION		2008/01/08	08:30:55

(UP,DOWN) MOVE	(PLAY) PLAY	(MENU) EXIT
(FF) SELECT MODE (SELECT) CHANGE

1. Start Time.	2. End Time.
3. TIME: Continuous record.	4. MOTION: Motion Triggered event.
5. Un-played video recording.

Chapter 8: USB DVR Access - 8.1 Program Installation

1.Put the USB Driver Program CD in your CD-ROM Drive. 2.Open CD directory.

3.Double click on Set up .

4.Run the install DVR Viewer program.

To Run the program Double click the program icon [ ] on the desktop. DVR Viewer will detect the hard drive automatically when user connects the USB cable to PC.

NOTICE: If the hard drive isn't detected, please restart and try the following: 1-Close the USB program window and remove the USB cable

2-Press [ ] then reconnect the USB cable to the PC and try again.

Page 9 Page 18